BL1200Te Agitators with Torque Converters

The Te Series incorporates a slip-ring type strain torque converter in the drive shaft, and displays and outputs the torque value after it has been amplified by the dynamic strain amplifier inside the control box. The agitating equipment can use the torque to carry out outstandingly accurate measurement of the changes in viscosity.

Features

Features

  • Carries out precise measurement of the actual load acting on the agitator blade using a strain type torque converter.
  • The torque value is output as an analog voltage so that changes in the viscosity can be understood.
  • During the agitation, even if there are changes in viscosity the set rotation speed will be maintained.
  • Utilizes a powerful brushless motor that does not generate sparks.
  • During agitating work, one-switch operation changes the rotation direction.
  • Does not output noise that would adversely affect other equipment, and incorporates measures to prevent mis-operation even when affected by noise.
  • Provided with protection equipment such as a current restricting circuit and thermal protector to protect against agitator motor overloading.

Contact us

Main specifications

Applications Low to Medium Viscosity
Rotation Speed 20~1200rpm
Rated Torque 0.3N・m
Motor DC Brushless Motor B Type Insulation 40W
Rotation Control Feedback Control and Forward/Reverse Rotation Switching (Timer mode, manual)
Forward/Reverse
Rotation Timer
5, 10, 20, 30, 45, 60 sec Setting Switching Possible
Torque Output Analog Voltage: DC0-1V=0-1N/m (0-10.2kgf/cm)
Panel Display Rotation Speed Digital 4 Digits, and Overloading Display; Torque Indicator (1 graduation 20%)
Chuck φ8mm Collet-type Hand-tightening Chuck
Safety Equipment Current Restricting Circuit, Thermal Protector: Motor Coil Temperature 90℃, Safety Cover
Power Cable 2m Power Cable with 2-pole Grounded Plug
Power Supply and
Consumption
Single Phase 100V±10% Joint Use 50/60Hz 120VA
Dimensions and
Weight
Main Unit: W135mm x D170mm x H264mm, 3.0Kg
Dynamic Strain Amplifier: W118 x D220 x H80, 750g
Standard
Accessories
Clamp Holder (Type: 21 x 16) 1 piece

Contact us

/* 20140217 add by takahashi */