TriboGear Gauge head

Sorry, this entry is only available in 中文 and 日本語.

ASTM flat indenter 30mm flat indenter Ball indenter
jigu_astm jigu_30 jigu_ball
Adapted specifications: ASTM D1894
Contact surface: 2.5X2.5inch
Can apply surface pressure to the paired test
pieces after the sheet-type test piece is wound
and fixed and the plate-type test piece is bonded.
Contact surface: 30X30mm
Can apply surface pressure to the paired test
pieces after the sheet-type test piece is wound
and fixed and the plate-type test piece is bonded.
Applies point pressure to the plate-and sheettype
test pieces using a secured ball which slides
the test pieces. This device is suitable to
measure the difference between the test pieces
based on the ball.
Application models
1418223034
HHS
Application models
1418223034
HHS
Application models
1418223034
HHS

 

Roll holder Blade holder Tack roller unit
jigu_rollholder jigu_blade jigu_tuck
Applies linear pressure to the plate -and sheettype
test pieces using a secured roller which
slides the test pieces. This device is suitable to
evaluate transportability.
This device is suitable to measure the wiping
resistance of the rubber blade and to measure
the sliding resistance of the shoe sole to the
floor.
Evaluates the stickiness of adhesives, floor
materials or cosmetics from the rolling
resistance of the stainless roller.
Application models
1430
Application models
14223034
Application models
14

 

Steel-wool holder Sand-contained
rubber eraser indenter
45degree pencil holder
jigu_stealwool jigu_eraser jigu_pencil
Holds steel wool, gauze or rubber in order to
measure changes in friction due to the abrasion
of the test piece surface.
Holds a cylindrical sand-contained rubber eraser
in order to measure changes in friction due to
the abrasion of the test piece.
Adapted specifications: JIS K5600 (scratch test)
Measures the scratch hardness of coated
surfaces and evaluates how smoothly pens or
pencils write.
Application models
1418223034
HHS
Application models
1418223034
HHS
Application models
1418223034
HHS

 

Scratch needle T-shape peeling unit Peeling clip
jigu_needle jigu_tflakingoff jigu_flakingoff
Adapted specifications: JIS K6718 Evaluates the
scratch hardness of various materials and the
adhesion of vacuum evaporated or paint film.
Adapted specifications: JIS P8139 This T-shape
unit allows the stable measurement of both
peeling resistance and tensile strength.
Measures the adhesion and removability of
adhesive tape or the peeling resistance and
tearing strength of combined board layers.
Application models
1418223034
HHS
Application models
14
Application models
141834

 

Contact us

Contact us

/* 20140217 add by takahashi */