TYPE:10 Static Friction Coefficient Tester
Easy Static Friction Coefficient Measurement Allows Use as a Research, Inspection and Teaching Aid
The test piece is installed on the ascending board and flat indenter. The ascending board is provided with a sensor that monitors the movement of the flat indenter.
The ascending board starts from the horizontal position, and the tilt increases when the measurement begins. The sensor detects the motion when the flat indenter begins to slide, and instantly stops the ascending board.
The angle and tan?? at this time should be read.
Power supply: 100 V AC only. A step-down transformer is required for use outside Japan.
Free Combination, Regardless of the Type of Material
Measurement of almost any kind of test piece surface can be carried out, including metal, fabric, paper, rubber, and film.
The test piece can be mounted either on the ascending board or the flat indenter.
By applying lubricant to the test piece, tribology research can also be carried out.
Sensor Detects the Movement As Soon As Sliding Starts
Since the ascending board rises smoothly and stops electronically, there will be no measurement variations between individuals.
The readings when the ascending board stops can be used as the slide angle (°) and the static friction coefficient (tanθ).
* Separate measurement jigs may be required.
Slide Angle 0-56° (Minimum Gradation 0.5°)
Flat Indenter: 75 x 35mm (Contact surface)
Vinyl Cover 1 piece, Operation Manual 1 book